Chapter 7: Trade management – Keeping risk under control

The 4-step Buy/Sell checklist tells you when a setup is complete. But before entering, 3 questions still matter: Where should the stop go? How much room is left to the target? And how much will the account lose if the trade is wrong? No risk-management approach can make every trade a winner. What matters is keeping losses within the limits you set before entering the trade.

7.1. Place your stop for a reason, not by feel

For a Buy, the stop generally belongs below the area where price began to turn higher. For a Sell, consider the corresponding area where price began to turn lower. These are levels worth considering because a move back through them may invalidate the original reversal idea. Do not set your stop just to reduce your potential loss by a few ticks or to trade more contracts. On Renko charts, pay attention to the actual execution price, not just the neatly formed bricks on the screen.

If RSI confirms late and the entry is far from a logical stop level, do not move the stop too close just to make the risk look more attractive. An ordinary price fluctuation could then be enough to stop you out. You can reduce position size to keep the potential loss within your limit, or skip the setup if the stop distance and remaining target distance no longer make sense together.

7.2. Make sure there is enough room to the target

Before entering, look for the nearest prior high, low, or price zone along the path of your planned trade where price has reacted before. That area may act as a barrier to price and serve as a reference for setting your target. Some traders prefer a fixed reward-to-risk ratio; whichever method you use should be defined and tested in advance. Avoid buying when price is already close to overhead resistance or selling when support is just below, especially when the stop is relatively far away.

For example, suppose the Buy checklist has just completed all 4 steps, but price is already approaching a prior high. If the stop belongs below the reversal-low area, the potential risk may be greater than the reward still available. The signal may still be valid, but taking the trade may no longer make sense. Make a habit of checking the target before entry to avoid rushed decisions.

7.3. Do not let 1 trade derail the entire session

Decide in advance how much you are willing to lose on each trade. Then calculate the number of contracts based on the distance from entry to stop and the value of each tick. Include commissions and potential slippage. There is no single risk percentage that works for everyone. Account size, contract type, and drawdown tolerance differ from trader to trader.

If you hold multiple positions in the same direction or in instruments that usually move together, evaluate total risk rather than each trade in isolation. Another rule to establish in advance is a daily or weekly loss limit. Once that limit is reached, stop trading, even if the chart produces an excellent-looking signal. Protecting the account matters more than trying to recover losses in the same session.

7.4. How should you handle an opposing signal while a trade is open?

While holding a Buy or Sell position, a Keltner reversal brick and Momentum signal in the opposite direction do not necessarily mean you must exit immediately. Sometimes they reflect a brief pullback; other times they are early signs of a stronger move against your position. Let your exit plan determine what to do: Where is the stop? Is there a profit target? How will you respond if the full opposing checklist is completed? Change your exit rules only after reviewing enough trades, not in reaction to the emotions of a single session.

Continue reading → Chapter 8: Balance areas – Why Precision OB/OS Solution prefers to stay out